Applying and understanding Manning’s formula.Observation of discharges under a radial gate:.Relationship between dam height and discharge.Observation of hydraulic motion on discharge.Observation of the flow under an undershot weir:.Generation of different flow states by damming the down-stream water.Comparison of overflow and syphon weirs.Flow rate and drain coefficients of a syphon weir.Amount of energy in flows in open channels.Discharge processes on an underwater weir.Investigation of flow and supercritical flow states.Characterization of the hydraulic jump.Measurement of flow using Venturi flume.Measurement of flow with changes in the channel section.Measurement of the flow with weirs of thin wall.Measurement of the water height and the velocity along the channel.
4 SYPHONER COMP MANUAL
GUIDED PRACTICAL EXERCISES INCLUDED IN THE MANUAL
4 SYPHONER COMP SOFTWARE
This Computer Controlled Unit is supplied with the EDIBON Computer Control System (SCADA), and includes: The unit itself + a Control Interface Box + a Data Acquisition Board + Computer Control, Data Acquisition and Data Management Software Packages, for controlling the process and all parameters involved in the process. There is a wide range of available accessories. The channel is assembled on two supports, with a system to control the inclination of the channel. Besides, a Pitot tube with tubes manometer board (CFTPC) us required to measure velocity/flow. The flow also can be measured with the flow sensor of the Basic Hydraulic Feed System (FME00/B).Ī limnimeter (CFRMC) is required to measure water level. To measure the flow there is an orifice plate flow sensor and a Venturi type flow sensor. To regulate the flow through the channel, there is a valve at the output of the pump. The unit includes the instrumentation and the suitable sensors (flow, pressure, etc.) to control and to measure the most representative parameters. Finally it comes back to the storage tank, completing the closed circuit. After that, the water flows through the channel that discharges in the reception tank. Water is taken from the storage tank by means of a hydraulic pump, with speed regulation, and, by the pipe, it is driven to the inlet tank, where there is a soothing of flow. Channel, through which water flows, of rectangular section with transparent walls that enable to observe all the experiments.
0 kommentar(er)
